Body caps
Camera body caps to 3D print
Body caps for Canon EF and RF, Sony E, Nikon Z, Fujifilm X, L-Mount, Micro Four Thirds, Leica M and ARRI PL cameras. They go on like a lens: the twist-on caps click in, the PL cap locks under the camera's locking ring. Print them face down, with a label such as A-CAM, your logo or the mount code on the face, or an AirTag hidden inside.
Not print-tested on a camera yet. Every file includes a fit test ring, the bayonet zone only: print it first and check the fit on your camera before the cap.
Canon EF / EF-S
Canon EOS DSLRs, full frame and APS-C (EF-S bodies take EF caps too).
€2.90 · fit ring included
Canon RF
Canon EOS R mirrorless cameras, full frame and APS-C (RF-S bodies take RF caps too).
€2.90 · fit ring included
Sony E / FE
Sony Alpha cameras with an E-mount, full frame (FE) and APS-C.
€2.90 · fit ring included
Nikon Z
Nikon Z mirrorless cameras, full frame (FX) and APS-C (DX).
€2.90 · fit ring included
Fujifilm X
Fujifilm X-series cameras: X-T, X-H, X-S, X-E and X-Pro bodies.
€2.90 · fit ring included
L-Mount
Panasonic Lumix S cameras, including the S1H, S5 II and the BS1H box camera.
€2.90 · fit ring included
Micro Four Thirds
Panasonic Lumix G and GH cameras and the BGH1 box camera.
€2.90 · fit ring included
Leica M
Leica M cameras, film and digital (M6, M10, M11 and others).
€2.90 · fit ring included
ARRI PL
PL-mount cinema cameras from ARRI, Sony (VENICE), RED, Blackmagic Design and others.
€2.90 · fit ring included
What every cap has
- The lens side of the mount, measured from body caps and adapters that fit real cameras.
- A hole for the camera's locking pin, so it clicks in like a lens (PL: four notches for the locating pin).
- Nothing that reaches deeper into the camera than a lens's own mount.
- Module 0.8 gear teeth like our focus rings, or a smooth flutes grip.
- A label up to 7 characters, your logo or the mount code, as a flush two-colour face or engraved.
- An optional snap-in AirTag pocket: one part, no screws or glue.
- A fit test ring with every file, the bayonet zone only, to print first.
DJI DL and DX (Ronin 4D) are planned. Tell us which mount you need: b.see@focusrings.at.